Troy bilt brush cutter manual

Includes: Flexible Drive Shaft. Back Order. Lowerible Drive Shaft. Air Filter Assembly. Split Boom Coupler Kit. Item : B. Recoil Starter Housing Assembly. Clutch Assembly. Fuel Tank Assembly. Load More Products.

Manuals Manuals Model. Model: 41ADZ59C Item : WLX-H Item : WLS-H Item : WLS Engine Displacement 25cc Fuel Tank Capacity 15 oz. Warranty 3-year limited. Handle Overmold. Additional Specifications. Specifications Disclaimer Specifications subject to change without notice and without incurring obligation. Products depicted on website and other advertisements are for demonstration purposes only.

Actual products offered for sale may vary in design, required attachments, safety features and non-functional appearance from. See other general disclaimers at the bottom of our website. Manuals Model. Find Parts. Do not smoke while fueling or mixing fuel.

Wipe up any spilled fuel from the unit immediately. Have any damage repaired before attempting further operations. Do not operate unit with a bent, cracked or dull blade. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information.

Page 8: Assembly Instructions On some units, the J-handle may be pre-installed. In this case you must loosen screws and adjust the handle to fit the operator. Go to step 5 if the J-handle is pre-installed. Place the J-handle between the top and middle clamp pieces Fig. Install the cutting attachment shield on the shield mount by inserting the three 3 screws into the shield mount. Page 10 5. Make sure that the cutting blade is centered on the pilot step and sitting flat against the output shaft bushing Fig.

Pilot Step Fig. Be sure to use fresh, clean unleaded fuel. Carbon monoxide exhaust fumes can be lethal in a confined area. To avoid serious injury, the operator and unit must be in a stable position while starting. Make sure that any Add-On item is installed correctly and secure before starting the unit.

TBGC Edger. Before operating the unit, stand in the operating position Fig. These procedures should also be a part of any seasonal tune-up. NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to any non-road engine repair establishment, individual or authorized service dealer. Single line can be used on either type of inner reel. Use Figure 30 to identify the inner reel you have.

Hold the outer spool with one hand and unscrew the bump knob clockwise Fig. Inspect the bolt inside the bump knob to make sure it moves freely. Replace the bump knob if damaged.